11
INSTALLATION INSTRUCTIONS & USER MANUAL
804428UK V1.03 OCT 2017 - ZIP EP HYDROTAP
TECHNICAL SUPPORT
TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UK
WWW.ZIPWATER.CO.UK
SECTION 2 FILTER & TAP INSTALLATION
•
Ensure that the mains cold water supply is
turned off.
•
Choose a suitable location, (cupboard back or
side wall).
•
Mount the filter head in an upright position,
using the screws supplied in the fittings kit.
•
Ensure there is enough headroom for the
filter cartridge to be easily fitted and removed.
*Allow a min. 80mm base clearance.
•
Attach the pipes as model installation
diagram (see section 3), noting the flow
directions as marked on the filter head and
non return valve (see sections 3).
*Min. 80mm
Clearance to
cabinet floor.
2.3 Filter installation
(see individual model arrangements pages 13-14)
Inlet
Outlet
Rotate
Insert
2.2 Mounting the filter head
Flow
Flow
Scale filter
Sub micron filter
Flow
Tee piece, stop
cock and flush line
(supplied)
2.1 Installing the filter system
•
The ¼” pipe supplied must be carefully measured and cut to allow for the connection
of the filter,valves and Command Centre.
•
Flush water through the supply line thoroughly before connection
•
Connect the pressure limiting valve to the isolating valve (not supplied).
•
Mount the filter head and connect the stop cock in a convenient position.
•
Connect the filter assembly plumbing between the pressure limiting valve and the
inlet of the Command Centre, using the ¼” tubes supplied. (ensure that the non
return valve is fitted) (see individual model arrangements pages 13-14).
•
Note the flow direction, arrowed on the top of the filter head & non return valve.
•
Ensure the flush stop cock is accessible after installation, this is required to flush
water through the filter, when the filter is installed or changed.
• Write the date of replacement on the new filter cartridge label.
• Remove the protective plastic cap from the filter cartridge, lubricate
o-rings with
water. (Do not use any petroleum products to lubricate the o-rings).
• Align the tabs of the cartridge with the filter head and insert it up into the filter head.
•
Turn the cartridge a quarter turn anti-clockwise until it stops and locks into position.
Note
Read and undertake in conjunction with the Command Centre
installation, see Section 3.
The external filter is a sub-micron scale filter designed to reduce scale build up in the tank, which also includes a
carbon block to improve taste and odour.
