19
INSTALLATION INSTRUCTIONS & USER MANUAL
804428UK V1.03 OCT 2017 - ZIP EP HYDROTAP
TECHNICAL SUPPORT
TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UK
WWW.ZIPWATER.CO.UK
USING THE BOILING CELSIUS TAPS
Filter warning light
As a reminder that the filter requires changing, the indicator light will perform a sequence of quick white flashes
every 10 seconds. (Refer to section 4.3 Filter replacement).
Filter reset
The internal filter counter and the flashing indicator light will need to be reset after the filter has been replaced. To
do this:
•
Hold the rotary control in either direction for 10 seconds to cause the tap to enter its ‘settings mode’.
Successfully entering this mode will cause the warning and safety lights to slowly flash alternative colours at a
slow rate. In this mode water cannot be dispensed.
•
Release the rotary control so it returns to its neutral position.
•
Tap the safety button 4 times. Successfully performing this will cause the warning and safety lights to flash
alternative colours at a rapid rate for 15 seconds.
•
The tap will exit its ‘settings mode’ and return to normal operation. The indicator light should now not be flashing
white indicating the filter counter has been successfully reset
Fault Warning Lights
If there is a fault with the system, both the safety light and the warning light will flash for 1/2 second ON and 1/2
second OFF until the fault is rectified. Call Zip on 0345 6 005 005.
Sleep mode
In SLEEP MODE the unit will Go to “Sleep” after 2 hrs of inactivity. The indicator light will flash once every 5
seconds to show that sleep mode is active. During sleep mode, water temperature is set to 68°C. To wake from
sleep mode, first touch the safety twice and then turn the rotary control.
The sleep mode setting can be enabled or disabled. To toggle the sleep mode setting:
Hold the rotary control in either direction for 10 seconds to cause the tap to enter its SETTINGS MODE.
Successfully entering this mode will cause the warning and safety lights to slowly flash alternative colours at a slow
rate. In this mode water cannot be dispensed.
Release the rotary control so it returns to its neutral position.
Press and hold the safety button for 3 seconds. Successfully performing this will cause the warning and safety lights
to flash alternative colours at a rapid rate for 8 seconds.
Before exiting the SETTINGS MODE the tap will show the current sleep mode setting.
If the sleep mode was just enabled, the safety and warning lights will simultaneously flash blue.
If the sleep mode was just disabled, the safety and warning lights will alternatively flash red.
By default the sleep mode setting is disabled.
