12
INSTALLATION INSTRUCTIONS & USER MANUAL
804428UK V1.03 OCT 2017 - ZIP EP HYDROTAP
TECHNICAL SUPPORT
TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UK
WWW.ZIPWATER.CO.UK
FILTER & TAP INSTALLATION
!
Read Important safety instructions, page 6 and Ventilation, page 10 before you start the installation.
•
Position the Command Centre as close as possible to directly beneath the tap head.
•
The braided hoses (Celsius range) and connection tubes supplied with the tap head assembly and cold inlet
CANNOT be lengthened.
2.4 Connecting the tap
(refer to individual model arrangements pages 13-14)
•
Measure and trim the RED silicone tube and connect it to the boiling water outlet located on the top of the
Command Centre.
•
Measure and trim the BLUE plastic pipe and connect it to the ambient outlet located on the top of the Command
Centre
(ambient models only).
•
Measure and trim the CLEAR silicone tube and connect it to the vent outlet located on the top of the Command
Centre.
•
For Celsius, connect the braided hoses (1/2" BSP fittings), see page 14.
Red marking - hot mains isolation valve.
Blue marking - cold mains isolation valve via T-piece and adaptor supplied.
•
Connect the tap USB connector to the USB port on the Command Centre. Orient the USB plug carefully and
connect, do not force the plug. Once connected, fix
the cable to the wall, ensure it is away from any possible
water splashes and is off the floor.
Note
When trimming silicon tubes, trim to minimum length, do not loop any excess or allow kinking of the tubes.
When connecting, slide the tube over the pipe at least 15mm.
3.1 Command Centre installation
(see individual model arrangements pages 13-14)
SECTION 3 COMMAND CENTRE INSTALLATION
