17
INSTALLATION INSTRUCTIONS & USER MANUAL
804428UK V1.03 OCT 2017 - ZIP EP HYDROTAP
TECHNICAL SUPPORT
TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UK
WWW.ZIPWATER.CO.UK
USING THE ARC & CUBE TAPS
Sleep mode
In SLEEP MODE the unit will Go to “Sleep” after 2 hrs of inactivity. During sleep mode water temperature is set to
68°C. To wake from sleep mode, first tap the safety twice and then turn the rotary control.
The sleep mode setting can be enabled or disabled. To toggle the sleep mode setting:
•
Touch the SELECT button to select boiling water mode with safety.
•
Hold the rotary control in either direction for 10 seconds to cause the tap to enter its ‘settings mode’. This is
easiest done by turning it clockwise and utilising the taps POT FILL mode. Successfully entering this mode will
cause the select and safety lights to slowly flash alternative colours at a slow rate. In this mode water cannot be
dispensed.
•
Return the rotary control to its centre position.
•
Press and hold the safety button for 3 seconds. Successfully performing this will cause the all three lights to
flash alternative colours at a rapid rate for 8 seconds.
•
Before exiting the ‘settings mode’ the tap will show the current sleep mode setting.
•
If the sleep mode was just enabled, the safety and select lights will simultaneously flash red and blue
respectively.
•
If the sleep mode was just disabled, the safety and select lights will alternatively flash red.
•
By default the sleep mode setting is disabled.
Red boiling water light
Continually illuminated
This indicates that the boiling water is ready to be dispensed.
Flashing slowly
This indicates Sleep Mode is active.
Flashing quickly
This indicates the boiling water is below usable temperature and the Sleep Mode is OFF.
White filter light
Filter light off
This indicates the filter is operating within its normal specified lifespan.
Filter light flashing slowly
This indicates the filter needs to be replaced. All three lights will start to flash when the counters have recorded 12
months of use or after dispensing 4000 litres, whichever occurs first.
To reset the filter light
•
Touch the SELECT button to select boiling water mode with safety.
•
Hold the rotary control in either direction for 10 seconds to cause the tap to enter its SETTINGS MODE. This is
easiest done by turning it clockwise and utilising the taps POT FILL mode. Successfully entering this mode will
cause the select and safety lights to slowly flash alternative colours at a slow rate. In this mode water cannot be
dispensed.
•
Return the rotary control to its centre position.
•
Tap the safety button 4 times. Successfully performing this will cause all three lights to flash alternative colours at
a rapid rate for 15 seconds.
•
The tap will exit its ‘settings mode’ and return to normal operation. The filter flash sequence should now not occur
indicating the filter counter has been successfully reset.
