WAN configuration
28
Z-Edge 64 Configuration Guide
shdsl-decoder-coeffA: ---------------> {366}:
shdsl-decoder-coeffB: ---------------> {817}:
shdsl-power-scale: ------------------> {29298}:
....................
Save changes? [s]ave, [c]hange or [q]uit: s
Record updated.
Note:
If sdsl-config or shdsl-config profiles exist before setting the
line-type parameter to shdsllatest or sdsllatest in the dsl-config
profile, the parameter settings will not be changed in the sdsl-config
or shdsl-config profiles. You may need to update these profiles to
change the line rate or enable autobaud.
Verifying connection with showlinestatus command
Verify that the DSL connection is operational by entering a showlinestatus
command for the WAN port. The showlinestatus command uses this syntax:
showlinestatus shelf slot port subport
The following example displays the status of the connection on shelf 1, slot 1,
port 1 (the WAN interface):
zSH> showlinestatus 1 1 1
Search in progress .........
.................
GroupId --------> 6
Status ---------> ACTIVE (1)
TxClk ----------> NONE (1)
RefClkSrc ------> NO
If_index -------> 3
Peer If_Index --> 0
Shelf ----------> 1
Slot -----------> 1
Port -----------> 1
SubPort --------> 0
Now that the WAN connection is active, you can proceed to configure rest of
the system.
Table 1: Automatic baud rate detection configuration settings
DSL line type setting
Fixed bit rate setting
Suggested line rates
sdsllatest
fix-bit-disable for
both CO and CPE
devices
CPE - 2320 kbps
CO - any supported rate
shdsllatest
shdsl-fix-bit-disable
for both CO and CPE
devices
CPE - 2320 kbps
CO - any supported rate
