Zhermack QUASAR, User Manual

Page: 143 / 296

QUASAR/QUASAR PLUS
143 of 296
MAINTENANCE AND USE MANUAL
EN
CAPITOLO 10: TROUBLESHOOTING
Should any of the anomalies described below occur try setting the situation right, as
far as is permissible, by following the instructions contained in this manual. Should
the problem persist contact your Authorised Servicing Centre.
p
Roblem
C
ause
R
emeDy
Infra-red lamp
does not work.
1. Plug not inserted properly.
2. Mobile protection screen
not closed properly.
3. Mechanical pointer not
positioned at limit stop.
4. power adjuster not set to
"zero".
5. Main switch damaged.
6. Infra-red lamp burnt out.
7. Electrical system damaged.
8. Fuses blown.
1. Insert plug in socket.
2. Close mobile protection screen.
3. Position mechanical pointer correctly.
4. Set power adjuster properly.
5-6-7-8. Contact Authorised
Servicing Centre.
Infra-red lamp comes
on but
does not weld.
1. Piece is not positioned at
exact heat focus point.
2. Infra-red lamp damaged.
3. Cover not perfectly clean.
1. position parts to be welded at the
exact heat focus point. If problem
persists contact Authorised
Servicing Centre.
2-3. Contact Authorised Servicing
Centre.
Job-holding pan
does not respond
to joystick
commands.
1. Mobile support damaged.
2. Mobile support jammed by
foreign body.
3. Joystick control damaged.
4. Mobile support needs
lubricating.
1-2-3-4. Contact Authorised
Servicing Centre.
9.2
PROBLEMS, CAUSES AND REMEDIES
9.1 WARNING