Zhejiang Qianjiang Motorcycle RKV 200, Service Manual, Page: 79 / 171

79
3.2 Fault Diagnosis
Stator motor cannot run Stator motor runs weakly Starter motor rotates but the engine
does not
•Broken Fuse •Low battery •Defective starter clutch
•Low battery •Poor connecting wire contact •Starter motor counter-rotate
•Defective ignition switch •Stator motor gear stuck by •Low battery
•Defective starter clutch foreign substances
•Defective braking switch
•Defective starter relay
•Defective connecting wire contact
•Defective starter motor
3.3 Starter Motor
3.3.1 Removal
* Attention
Before removing starter motor, the ignition switch must be
set at “OFF” position. Disconnect battery grounding wire
and then turn on the power supply to check if the starter
motor runs to confirm safety.
First remove the lead-wire clip of starter engine.
Remove starter motor pinch bolt and take down the starter
motor.
Roll up the rubber waterproof jacket and remove starter motor connector.
3.3.2 Disassembly
Disassemble housing screw, front cover, motor housing and
other parts.
3.3.3 Inspection
Inspect other component assemblies.
Replace with a new one when there is surface partial friction,
injuries or burning loss.
Commutator shall be cleaned when there is metal particles
adhered to its surface.
Inspect for continuity between contact surfaces of other