Zhejiang Qianjiang Motorcycle RKV 200, Service Manual, Page: 104 / 171

104
7. 3. 4 Installation
Installation must be initiated in the reverse sequence of disassembly.
Attention:
Lubricate the front wheel shaft, gear housing component, oil seal, bearing sleeve, rolling bearing (6301) and
intermediate sleeve.
The recommended lubricant is calcium-base grease.
Install the front wheel shaft (1), front wheel, gear housing component (2)
and nut M12Χ1.25.
It is important that the gear housing component should be aligned when it is
being installed.
Odometer gear housing
The odometer gear housing component will deform if the component is not
aligned to the locked front wheel shaft.
The front hydraulic bake component is mounted onto the hydraulic braking
disc.
Tighten the front wheel shaft.
*Note: See P75 of this manual for disassembly of QJ200-2A front wheel.
7. 4 Steering handlebar
7. 4. 1 Disassembly
Dismantle the right and left rear mirrors (1) and (2).
Open the fixed cover.
Remove the left handle component (9) of the front brake.
Remove the balancing block component (3)
Remove the right and left combined switches (5) and (7).
Remove the left handle grip (8) and throttle control handle (4) and
fixed screws onto the upper base of steering handlebar.
Remove the upper base.
Remove the steering handlebar component.
7. 4. 2 Installation