Zhejiang Qianjiang Motorcycle RKV 200, Service Manual, Page: 57 / 171

57
Adjust drive chain slackness:
Screw off rear shaft nut and locknuts of adjusters on both drive chains.
Rotate uniformly both adjusters till the drive chains gain normal slackness.
* Attention
Do not install new drive chains onto worn sprockets or install worn drive chains onto the new
sprockets.
Keep both sprocket and drive chain in good conditions, or
newly replaced chain or sprocket will be worn soon.
Clearance of front/rear brake
Front brake clearance
Measure clearance of front brake at the tip of front brake
handle.
Clearance: 10-20mm
Brake pedal clearance
Measure brake pedal clearance.
Clearance: 20-30mm.
If the clearance measured does not meet the specified value,
adjust it.
Adjust clearance of brake pedal.
Screw in or screw out the adjuster.
If the adjuster is screwed in, clearance is increased; if
screwed out, clearance is decreased.
Adjust till the clearance is up to the specification.
After adjustment, the brake shall not drag.