Zhejiang Qianjiang Motorcycle RKV 200, Service Manual, Page: 115 / 171

115
Note: See P101 for details of removal and installation.
8. 4. 5 Check of rear swingarm
Check the mounting shaft of rear swingarm and turn the shaft or measure it with a micrometer gauge after it is
placed onto a flat surface. If the shaft is bent, replace it.
*Attention
Do not attempt to straighten bent shaft.
Clean parts of rear swingarm mounting shaft with a solvent.
Check rear swingarm shaft sleeve component (2) and intermediate sleeve (3),
and if any damage is found, replace it.
8. 4. 6 Installation of rear swingarm
Installation must be initiated in the reverse sequence of disassembly.
Apply grease onto the pivot bushing.
Check rear swingarm shaft sleeve component (2) and intermediate sleeve (3).
Install chain guard.
Load the swingarm onto the frame and insert the rear swingarm,
Install the swingarm shaft nut to the specified torque force.
Install the lower fixing screw of the rear shock absorber.
Install the driving chain cover.
Install the two connecting bolts.
Install the rear wheel.
Nut, rear swingarm shaft
Torque force value : 70-83N·m
8. 5 Chain drive assembly
8. 5. 1
．
Disassembly
Stop the motorcycle on the flat ground, and support it securely.
Remove the connector of gear shift pedal, driving sprocket cover
and driving sprocket.
Remove the rear wheel, rear shock absorber, sprocket housing and
driving chain.
Rear swingarm shaft