ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 34 / 160

INSTALLATION
Page 26
• One for the Astern Clutch solenoid
• One for Clutch Power
A) Insert the Harness plug into the CLUTCH plug-in on the Processor
Cover.
B) Run the two cables labeled Ahead and Astern Clutch to the transmis-
sion.
C) Refer to the Transmission documentation for termination points at the
clutch solenoids.
D) Run the one cable labeled Power to the Clutch Power Supply. Con-
nect to the Power Supply.
5.6.2 Clutch and Troll Control
The Clutch/Troll Harness is supplied with 3 or more of the following
Cables extending from the plug.
• One for the Troll Command solenoid
• One for the Troll ON/OFF solenoid
• One for Neutral Clutch solenoid
• One for Ahead Clutch solenoid (refer to Section 5.6.1)
• One for the Astern Clutch solenoid (refer to Section 5.6.1)
• One for Clutch Power (refer to Section 5.6.1)
A) Insert the Harness plug into the CLUTCH connector on the Processor.
B) Run the two cables labeled Troll Command and Troll ON/OFF to the
transmission.
C) Refer to the Transmission documentation for termination points at the
Troll solenoids.
D) Run the three cables labeled Ahead, Neutral, and Astern Clutch to the
transmission.
5.7 E
NGINE
S
TOP
S
WITCH
The Installer supplies the Stop Switches. Refer to the information sup-
plied with the Stop Switches for installation.
WARNING: Each Station must have some method to stop the engine, refer to CFR 46, SEC. 62.35-5
and ABYC P-24.5.8.