ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 50 / 160

SET-UP PROCEDURES
Page 42
6.3.19L2 - Troll Minimum Pressure
This Function is accomplished during Adjustments.
6.3.20L3 - Troll Maximum Pressure
This Function is accomplished during Adjustments.
6.3.21L4 - Troll Throttle Limit
This Function is accomplished during Adjustments.
6.3.22L5 - Troll Pulse Duration
This Function is accomplished during Adjustments.
6.3.23L6 - Troll Pulse Percentage
This Function is accomplished during Adjustments.
6.3.24H0 - Diagnostic
This Function is used during Troubleshooting.
6.3.25H1 - Erase EPROM
This Function is used during Adjustments or Troubleshooting. (For
Authorized Personnel Use ONLY)
6.3.26H2 - High Side Driver Fault Enable
The five drivers used for controlling clutch and troll solenoids can be
monitored. The presence of an open or shorted circuit can be detected.
The installer must program the system so that the fault detection software
is enabled for the desired drivers.
The High Side Driver Fault Function is set at the factory for 00 with none
of the Driver Fault detection Enabled.
To change the value:
A) Depress either the Up or Down Arrow to activate the Function
Menu.
B) Use the Up or Down arrow to scroll to the H2 Function Code.
C) Activate Set-up Mode. Refer to Section 6.2.
Figure 47: H2 High Side Driver Fault Function Set-up Activated
Function Code is blinking