ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 33 / 160

INSTALLATION
Page 25
5.4.1 Tachometer Sensor Wire Harness (Active Synchronization Only)
(Multi Screw)
This Harness will be plugged on both ends of the cable. The plug on the
Sensor side is designed to mate with the ZF Mathers supplied Tachometer
Assemblies.
A) Remove from the Processor the PULSE connector cap and discard.
B) Insert the Tachometer Sensor Wire Harness plug into the PULSE
connector on the Processor.
C) Run the Port Tachometer Sensor Cable to the Port engine pulse
transmitter.
D) Run the Starboard Tachometer Sensor Cable to the Starboard
engine pulse transmitter.
E) Make cable connections at the tachometer as indicated by the
Engine Manufacturer’s documentation.
5.5 M
AIN
E
NGINE
S
PEED
C
ONTROL
- T
HROTTLE
H
ARNESS
The Processor(s) connects directly to the engine interface using a
Throttle Wire Harness.
Refer to Appendix A.1 - Parts List to select the correct Throttle Wire
Harness for the engine signal required.
A)Connect the plug end of the Throttle Wire Harness into the
THROTTLE connector at the Processor.
B) Run the cable to the engine interface.
C) Refer to the engine documentation for termination points at the
engine interface.
5.6 C
LUTCH AND
T
ROLL
[
OPTIONAL
] C
ONTROL
These Harnesses will be plugged on the Processor end of the cable
only. Refer to Appendix A.1 - Parts List for the correct Harness for
this application. Refer only to the Sections that apply to the Harness
being used in this application.
5.6.1 Clutch Control Only
The Clutch Harness is supplied with 3 Cables extending from the plug.
• One for Ahead Clutch solenoid
NOTE: Ensure all Processors are set-up using the same Wire Harness and Set-up Engine Selection.