ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 26 / 160

INSTALLATION
Page 18
5.0 INSTALLATION
Before starting the actual installation of CruiseCommand, make sure you
have the correct parts and tools. See Section 3. Read ALL the instruc-
tions pertinent to each part before beginning the installation of that part
5.1 P
ROCESSOR
A)Place the Processor on the mounting surface and mark the three
screw holes.
B)Remove Processor and drill the screw holes.
C)Secure the Processor using 1/4 inch or M6 fasteners.
D)Connect to the Bonding System.
5.2 P
OWER
/S
TART
I
NTERLOCK
/(
OPTIONAL
) C
LUTCH
P
RESSURE
/
(
OPTIONAL
) A
LARM
C
IRCUIT
H
ARNESSES
Refer to Appendix A.1 Parts List for the correct Harness for this appli-
cation. Refer only to the Sections that apply to the Harness being used
in this application.
NOTE: When connecting the plugs, ensure that the release buttons are depressed and held until
plug is fully connected. To disconnect the plugs, the release buttons MUST be held
depressed until plug is disconnected. Refer to Figure 12:, page 22.
NOTE: When installing the harness cable, support the cables using clamps or straps not more than
18 inches
(0,5m)
apart, unless contained in a conduit. Install each cable so it is protected
from physical damage. Refer to ABYC Standard E-9.
Figure 16: Processor Installation