Written by:.JBJ
Checked by: AC
Document Number: Premier MX Inst Rev: 2
Page 32 of 44
14/12/06
Zones; Config Delay Zones; Config Delay O/Ps] and move the switch
actuator on each switch to the On position.
o
The Config Enabled LED on the motherboard will flash.
o
The Panel’s System Fault LED will flash and the buzzer will operate.
o
Any standing fault or disablement indications will clear.
o
It will not be possible to enter the Select Mode.
•
Press the Disable button on the panel’s display.
•
Return DIL switches 1-4 to 1-8 to the OFF position.
o
The Config Enabled LED on the motherboard will clear.
o
The Panel’s System Fault LED will flash and the buzzer will clear.
o
The factory default configuration [all zones as latching fire, non-delay,
standard [non- intrinsically safe] will be restored and the Fire Routing,
Fire Protection and Sounder outputs will no longer be delayed
15.4
Engineer’s Zone/Output Configuration Time-out Warning:
This feature is provided to prevent the panel being left in the Zone/Output
Configuration condition.
•
1 minute after the last button press:
o
The panel buzzer will restart.
o
The Select LED will flash.
o
The System Fault LED will continue flashing.
•
Press the Select On/Off button to continue with the configuration process
otherwise quit the configuration process as described in above.
15.5
Invalid Configuration conditions:
•
Invalid condition: If 2 or more configuration switches on the motherboard
are in the On position at the same time:
o
The Config LED on the motherboard will flash.
o
The System Fault and Select LEDs on the display will flash.
o
The fault relay will operate.
o
The panel buzzer will sound.
o
The Cursor indication will clear.
o
Configuration will be inhibited.
•
To clear the invalid condition check the zone and output config switches
[1/4, 1/5, 1/6, 1/7, 1/8] on the motherboard and ensure that only one is
selected to ON.
•
Invalid condition: Selecting any config mode switch [1/4, 1/5, 1/6, 1/7,
1/8] to the On position whilst the panel is in the fire condition.
o
The Config LED on the motherboard will flash.
o
The System Fault and Select LEDs on the display will flash.
o
The panel buzzer will sound.
o
The Cursor indication will clear.
o
Configuration will be inhibited.
