ZeptoMux user manual
v1.05
2.
Configuring the IP address (optional)
By default, the ZeptoMux is configured as
a DHCP client which falls back to the static
IP address (defaulted to 192.168.0.1) if the
DHCP request times out after 60 seconds.
If this behaviour is not desired, the
procedure for setting the static IP address
is as follows:
1.
Attach the supplied serial console cable to the ZeptoMux and to your PC.
You should see the serial-mode command line.
2.
Enter the user name ("
admin
") and default password ("
admin
").
3.
Enter "
enable
", to enable "privileged mode". The default password is blank
(just press
Enter
). There is more information about the privileged password in
the next section:
Changing the default passwords (optional)
.
4.
To assign an IP address of your choice, enter the command "
set
management address static <ip address> [netmask] [gateway]
".
Example: "
set management address static 10.10.10.11
".
You have now configured the ZeptoMux IP address and can connect the
device to the network, bypassing DHCP IP address allocation.
3.
Changing the default passwords (optional)
There are two passwords that you may wish to
change:
a)
Login password
(default is "
admin
").
b)
Privileged password
(default is blank – just
press
Enter
).
To change these passwords:
1.
On the command line, enter "
enable
".
2.
When prompted for the privileged password, press
Enter
(the default).
3.
To change the login password, enter the command "
set password
" and
follow the prompts.
4.
To change the privileged password, enter the command "
set enablepass
"
and follow the prompts.
5.
To make sure your new passwords are saved in the startup-config file, enter
the command "
copy running-config startup-config
". For more
information about this, see page 23:
Saving startup-config
.
NOTE: The
user name
cannot be changed and is always "
admin
".
zeptonics.com/support
© 2012 Zeptonics Pty Ltd
16 of 35
