ZeptoMux user manual
v1.05
The ZeptoMux will send its serial number (displayed on the side of the ZeptoMux)
as the name in the DHCP request. For setups where this name is automatically
passed to the DNS server, the ZeptoMux can be resolved by this serial number.
If you wish to specify an IP address for the ZeptoMux, which may be static, this is
explained in step 2 of
Setting up the ZeptoMux
.
Accessing the ZeptoMux
Commands are available to configure the ZeptoMux and view its operation. A
full list of commands is shown in
Appendix A: Commands
. You can enter these
commands either through a command-line interface or web interface using a
browser.
The ZeptoMux is accessed using its IP address. You will be asked to enter the
login user name and password. The password can be changed. The user name
is "
admin
" and cannot be changed.
In order to make changes to the configuration, such as assigning filters to
specific ports, the ZeptoMux must be put into a special mode called the
"privileged mode". This is described on page 13 under
Privileged mode
. To
change to privileged mode, you will need to enter the "privileged password"
(which is blank by default).
Web and command-line interfaces
All commands are available through the command-line interface. The web
interface does not currently support all commands.
The default username is "
admin
" and the default password is also "
admin
".
Command-line interface
Connect via serial or via ethernet using SSH or telnet. Enter the protocol and the
IP address as shown, then enter the login password.
Figure 5: Command-line interface.
SSH:
Serial:
Telnet:
zeptonics.com/support
© 2012 Zeptonics Pty Ltd
11 of 35
