
KEM
Technical Support:
28
2.4
HEAT/COOL QUANTITY
KEM can measure the calorific energy consumed by water-operated climate systems. At
least one water channel and two temperature probes must be enabled.
The 2 temperature probes are installed at the input and output of the climate circuit. In
this way, the calorific energy consumed is calculated from the volume of water consumed
and the temperature difference.
2.4.1
CONFIGURATION
On this screen, the basic configuration common to all KEM channels of heat quantity can
be configured. It is possible to enable or disable the different channels and partial
registers.
ETS PARAMETERISATION
The
“Configuration” tab parameters are shown below:
Figure 19.
Heat Quantity
– Configuration
Heat Quantity x
[
Enabled
/ Disabled
]: if any of the channels is enabled, a new
tab appears on the left menu. For more information see section 2.4.2.
Note:
at least one water channel and 2 temperature probes must be enabled
to enabling any heat quantity channel.
When one of the channels of heat quantity is enabled, the following parameter
appear:
Number of Partial Registers
[
0
/ 1 / 2
]: analogous to the same parameter
explained in electricity section (see section 2.2.1).