Zennio KEM, User Manual, Page: 21 / 49

KEM
http://www.zennio.com Technical Support: http://support.zennio.com
21
2.3 WATER
In addition to the electrical consumptions, KEM is able to monitor water flows and
consumptions of up to 4 channels.
2.3.1 CONFIGURATION
On this screen, the basic configuration common to all KEM channels can be selected. It
is possible to enable or disable the different channels and water global objects.
ETS PARAMETERISATION
The
“Configuration” tab parameters are shown below:
Figure 12. Water
– Configuration
Channel x [ Enabled / Disabled ]: if any of the channels is enabled, a new tab
appears on the left menu. For more information see section 2.3.2.
If at least one of the channels is enabled, the following parameters are also available:
Number of Partial Registers [ 0 / 1 / 2 ]: analogous to the same parameter
explained in electricity section (see section 2.2.1).
In this case, enabling at least one partial register, the objects
“[Water][Chx][PRn] Consumed Water”
will be displayed (see section
2.3.2.2).
Show Global Objects [ Enabled / Disabled ]: this parameter enables the global
objects where the accumulated water consumption data is stored. The
following parameters are displayed: