KEM
Technical Support:
19
Figure 10.
Electricity - Phase x - Total Register
Energy Value After Download
[
Keep Current Value /
Set Value
]: sets the
initial value of the total register of
energy
after an ETS download. When
selecting “Set value”, an additional textbox appears to enter the desired value
for
Consumed energy
, in terms of the selected measurement units.
Sending Mode for Energy
[
Disabled
/ Periodic / With Value Change / Periodic
and with Value Change
]: analogous to the same parameter of the
“Configuration” tab (see section 2.2.1) applied to the phase being configured.
The communication object
“[Elec][Phx][TR] Consumed Active Energy”
will always be
available when the phase is enabled. This object will store the accumulated value of the
consumed energy of the corresponding phase. It can only be initialized by writing on it
the desired energy value.
2.2.2.2
PARTIAL REGISTERS
Up to 2 partial registers can be enabled to store the energy values of each phase during
a period of time (for example, a day, a month …).
Two binary objects “
Reset Partial Registers 1
” and “
Reset Partial Registers 2
” are
available to reset a partial register anytime (set to zero). Moreover, a
periodic reset
can
be configured by parameter (see section 2.1.2).
Each time a partial register is restarted, the reset date is stored in
“Starting Date Partial
Registers n
”
and the values of the partial register are sent to the bus.
Note:
Partial registers are disabled by default. Please refer to section 2.2.1 for enabling
them.