ALLinBOX 161
/ 88 / 46 / Hospitality
Technical Support:
10
Overload LED (OVERLOAD)
: notifies a high consumption on the KNX bus
and/or the auxiliary power output line.
➢
OFF: normal power consumption on the KNX bus and/or the auxiliary power
output line.
➢
ON (red): overload on bus KNX and/or auxiliary power output line
*
.
➢
BLINKING (red): cut-off due to overload on the KNX bus and/or the auxiliary
power output line
*
.
* Reduce the load on the bus and/or the auxiliary power output lines until its
total consumption does not exceed the maximum current specified.
Programming LED
:
➢
OFF: normal operation.
➢
ON (red): programming mode active.
➢
BLINKING (red): safe mode active.
➢
ON (green): test mode active.
➢
BLINKING (blue): the device is initializing.
IP Factory Reset LED:
➢
OFF: normal operation.
➢
ON (red): IP restored by DHCP.
➢
ON (green): static IP (of ETS configuration) restored.
➢
ON (yellow): IP restored by APIPA.
Note
:
Please refer to section 1.5 for further details.
Reset LED:
➢
OFF: normal operation.
➢
BLINKING (red):
“Reset” button is pressed / short circuit on the KNX bus.
