ALLinBOX 161 /88 / 46 / Hospitality
Technical Support:
33
After entering the Test On mode, it will only be possible to control the outputs through
the IR remote control pushbuttons. Orders received through communication objects will
be ignored, with independence of the channel or the output they are addressed to.
In order not to interfere with the normal operation of the device, and because the Test
On mode is only intended to be used for testing purpose, when leaving the Test On
mode
the device will recover its outputs to the previous state.
Depending on the output parameterisation, the reactions to the button presses will differ.
Individual output
: short or long pressing the button will commute the on-off
state of the relay.
Shutter channel
4
: pressing the button will make the shutter drive move upward
or downward (depending on the button) until the button is released again, thus
ignoring the position of the shutter and the parameterised times.
Note
:
after leaving the Test On mode, the status objects will recover the values
they had prior to entering Test On. As the device is never aware of the actual
position of the shutter (as the shutter drive does not provide any feedback),
these values may not show the real position. This can be solved by performing
a complete move-up or move-down order, or by calibrating the shutter position
in the Test On mode until it matches the status objects.
Fan Coil module
: the behaviour will be different for the buttons identified as
fan and the identified as valve (see Table 1):
➢
Fan
: a short or long press will switch the relays to set the selected speed,
unless it matches the current speed
– in such case all the relays will be
opened (speed 0).
Note
:
the behaviour of the relays will depend on the parameterisation, i.e.,
on the number of fan speeds, on the delay between switches and on
whether the control type is accumulation or switching.
➢
Valve
: a short or long press will switch the current status of the relay and
therefore of the valve.
4
In the case of ALLinBOX Hospitality, it is not possible to configure the outputs as a shutter
channel, so what it is explained in this section does not apply.
