67 Rev.A
Overview of important operating and display fields in the X-Over settings:
Setting
Operation
2-way
Tap to activate or deactivate the 2-way audio crossover.
On: 2-way audio crossover activated.
Off: 2-way audio crossover deactivated.
HPF (front)
< >
Tap the arrow keys to set the high-pass filter.
Possible settings: Off (factory setting) 50 Hz/65 Hz/80 Hz/100 Hz/125
Hz/160 Hz
HPF (rear)
< >
Tap the arrow keys to set the high-pass filter.
Possible settings: Off (factory setting) 50 Hz/65 Hz/80 Hz/100 Hz/125
Hz/160 Hz
SET SUBWOOFER
1. Call up audio settings.
2. Tap on “subwoofer” to call up the subwoofer settings.
3. Set required subwoofer phase, gain and low pass crossover frequency, see table. The changes
are taken over automatically.
Overview of important operating and display fields in the subwoofer settings:
Setting
Operation
Power
Tap to activate or deactivate the Subwoofer Cinch output.
On: Volume in accordance with setting.
Off: Mute
INFO:
Acts exclusively on the Subwoofer Line-Out.
LPF
< >
Tap the arrow keys to set the low-pass filter.
Possible settings: OFF 160 Hz/125 Hz/100 Hz (factory setting)/80 Hz/65 Hz
Phase
Tap to set the subwoofer phase.
Possible settings: 0° (factory setting) / 180°
Gain
< >
Tap the arrow keys to set the Subwoofer Level (GAIN).
Possible settings: -6 < 0 > +6
RUN-TIME CORRECTION, GENERAL
Because of the given arrangement of the individual speakers in your vehicle, it may be that the
platform depiction is not optimal. The ZENEC run-time correction allows you to delay the audio
signal to the respective speakers in such a way that you have a central auditory experience.
SET RUN-TIME CORRECTION
1. Call up audio settings.
2. Tap on “Run-time correction” to call up the run-time correction settings.
Summary of Contents for Z-E3776
Page 1: ...EN Z E3776 INFOTAINER OPERATING INSTRUCTIONS...
Page 83: ...83 Rev A...