40
Operation
626140-9149-911
Operating manual TEMPAR console V9.0
The logging in of TEMPAR to an active directory server can be configured
in the area"
Active Directory
". After entry of the connection data, click
on "Connect to Active Directory”. If necessary a "Connection status test”
can be performed. Please note that to function reliably, "Active Directory”
requires an NTP time server (see Operating manual, Network chapter).
3.2.17
"Configuration > Measuring Room > Machines"
menu
Fig. 37:
"Machines" menu
Via the "Configuration" menu on the top right, the sub-menu
"Measuring Room" can be accessed and this is subdivided into several
tabs. The "Machines” tab contains the following information.
The name of the local measuring room is displayed in the "
Measuring
Room
" area. The name "Measuring Room 1" is activated by a click and
can be renamed.
If signal devices are connected to the console, they can be selected and
activated or deactivated. Signal devices are automatically detected on the
sensor bus and listed under “Choose signal device”. To activate a signal
device, select it and confirm.
In the "
Machines
" area, up to ten test and measuring machines can be
selected that are to be monitored from the console. The specification
values can be set for each machine. In addition to the Carl ZEISS
machines listed, ten freely configurable entries are available (CMM 1 to
CMM 10).
Clicking the "Reset” button restores the original values.
