INTRODUCTION
Colibri 7
Notes on device safety
ZEISS
02/2017
423052-7344-001
5
1
INTRODUCTION
1.1
Notes on device safety
The Colibri 7 solid-sate light source has been designed, produced and tested in compliance with the
European standard DIN EN 61010-1 (IEC 61010-1), "Safety requirements for electrical equipment for
measurement, control and laboratory use", meets the requirements set forth in the RoHS Directive
2011/65/EC and carries the
mark.
The Colibri 7 solid-state light source meets the Low Voltage Directive 2014/35/EU and the EMC Directive
2014/30/EC.
The devices must be disposed of in compliance with the WEEE Directive 2012/19/EC.
This operating manual contains information and warnings that must be followed by the operator.
The following warning and information symbols are used in this operating manual:
CAUTION
This symbol indicates a potential hazard to the user.
CAUTION LED radiation!
LED risk group 3 according to DIN EN 62471:2009 when the user looks directly into the
Colibri 7 light output.
UV radiation is emitted.
Any direct looking into the Colibri 7 light output is to be avoided.
Failure to heed this caution may result in eye damage.
Skin and eye irradiation is to be minimized by appropriate shielding.
WARNING of possible laser radiation!
The safety screw for fastening the lamp module to the microscope may only be removed by
ZEISS Service (not a customer interface). Otherwise there is a risk of eye damage upon laser
coupling.
CAUTION: High-energy UV radiation!
Risk of damage to the eyes and skin!
CAUTION
Disconnect the device from the line before any intervention!
CAUTION
Hot surfaces on lamp module!
ATTENTION
This symbol indicates a potential hazard to the instrument or system.
NOTE
This symbol designates information that should be closely followed.
