User’s Manual 1PH HYD3000-HYD6000-ZP1
Rev. 1.0 01/09/2023
Identification: MD-AL-GI-00
Rev. 1.1 of 27/01/2023 - Application: GID
85/193
6.18.
Three-phase DTSU Meter parameter configuration
After you have successfully connected the wiring, you need to set the correct parameters from the Meter
display.
Figure 50 – Meter legend
Three-phase DTSU Meter configuration to exchange
To view the device in read mode on the exchange you need to enter the settings menu, as indicated below:
1.
Press
SET
the inscription will appear
CODE
2.
Press
SET
, the inscription will appear “600”:
3.
Write the figure “701”:
a.
From the first screen where the number "600" appears, press the " key once to enter the
number "601".
b.
Press "SET" twice to move the cursor to the left to highlight "601";
c.
Press the" " key once more until you enter the number "701" (701 is the access code to the
settings).
Note:
In case of error press "ESC" and then again "SET" to reset the required code.
1.
Press to:
•
“Confirm”
•
“Move the cursor”
(for entering values)
2.
Presso to “go back”
3.
Press to “slide”
