Zapi ACE2, User Manual

Page: 58 / 85

Page - 58/85 AF2ZP0CL - ACE2 - User Manual
8.8 Sequence for Ac Inverter Pump setting
When the "Key Switch" is closed, if no alarms or errors are present, the Console
Display will be showing the Standard Zapi Opening Display.
If the controller is not configured to your requirements, follow the sequence
detailed on Chapter 9.2. Remember to re-cycle the Key Switch if you make any
changes to the controller’s configuration. Otherwise follow the sequence detailed
below:
1) Select the Options required. See Chapter 8.4.2.
2) Select and set the Battery Voltage. See Chapter 8.4.2.
3) Confirm correct installation of all wires. Use the Console’s TESTER function
to assist.
4) Perform the lift signal acquisition procedure using the Console “PROGRAM
VACC”. Procedure is detailed on Chapter 9.4.
5) Set the "MAXIMUM CURRENT” Current, using the table on Chapter 8.5.2.
6) Set the Acceleration and Deceleration Delay requirements for the pump.
7) Set the “FREQUENCY CREEP” level starting from 0 Hz. The pump should
just turn when the request microswitch is closed. Increase the level
accordingly.
8) Set the Speed Reductions as required. Make adjustments to “CUTBACK
SPEED 1”. Check the performance with the full request. Check the
performance with and without load.
9) Set “MAX SPEED LIFT” , max speed of pump motor when Lift enable switch
is closed.
10) Set “1ST SPEED COARSE”, speed of pump motor when SPEED1 switch is
closed.
11) Set “2ND SPEED COARSE”, speed of pump motor when SPEED2 switch is
closed.
12) Set “3RD SPEED COARSE”, speed of pump motor when SPEED3 switch is
closed.
13) Set “HYD SPEED FINE” to adjust the hydraulic steering speed (pump motor
speed when HYDRO function is requested).
14) Set “AUXILIARY TIME” (time delay before pump stops when an hydraulic
steering function request is switched off).
15) Set “SET TEMPERATURE”, setting the motor thermal sensor type used.