Zapi ACE2, User Manual

Page: 34 / 85

Page - 34/85 AF2ZP0CL - ACE2 - User Manual
8.4 Function configuration
8.4.1 Traction
Using the CONFIG MENU of the programming console, the user can configure
the following functions (see "OPERATIONAL FEATURE" chapter for an
explanation of "hydraulic steering function"):
SUBMENU "SET OPTIONS"
1) DISPLAY
TYPE
This parameter decides wich display is connected to the inverter.
0: No Display
1: MDI PRC connected
2: ECO DISPLAY connected
3: SMART DISPLAY connected
4: MDI CAN connected
2) TILLER SWITCH
This option handles the input CNA#6 . This input opens when the operator
leaves the truck. It is connected to a key voltage when the operator is
present. There are two levels:
-
HANDLE: CNA#6 is managed as tiller input (no delay when released).
- SEAT: CNA#6 is managed as seat input (with a delay when released -
debouncing function)
3) HOUR COUNTER
- RUNNING: the counter registers travel time only.
- KEY ON: the counter registers when the "key" switch is closed.
4) CUTBACK MODE
OPTION#1, PRESENT or OPTION#2.
-
If option 2.5 POT is ON:
OPTION#1: A13 is a handbrake.
PRESENT: A13 is a speed reduction request.
OPTION#2: no function for A13.
- If option 2.5 POT is OFF:
OPTION#1: A13 is a handbrake.
PRESENT: A13 is a speed reduction request.
OPTION#2: A13 is enable input.
5) BATTERY CHECK
- ON: the battery discharge level check is carried out; when the battery
level reaches 10%, an alarm is signalled and the maximum current is
reduced to the half of the programmed value.
- OFF: the battery discharge level check is carried out but no alarm is
signalled.
6) STOP ON RAMP
- ON: the stop on ramp feature (truck electrically hold on a ramp) is
managed for a time established by "auxiliary time" parameter. After this
time, the behaviour depends on the "aux output #1" option programming
(see also the following table).