16
ZABER TECHNOLOGIES INC.
In situations where mounting is not necessary, 4 adhesive rubber feet are provided which can be
applied to the underside of the unit to prevent it from sliding on the surface of a desk or table.
To apply the feet, peel each from the protective backing and place them firmly in the corner
recesses on the underside of the unit.
7. Manual Control
Most X-Series motion control products have an integrated, depressible knob with 20 detents per
revolution, allowing devices to be controlled without the use of a computer. There are two manual
movement modes available: Velocity and Displacement. Switch between these modes by holding
down the knob for 1 second or by configuring the knob.mode (T:109) setting.
On power-up, the device will only travel towards the motor from its start-up position until the home
position is reached. Once the device has been homed, the full range of travel becomes available.
