YZ Systems NJEX 8300G, Manual, Page: 76 / 126

YZ Systems, Inc. • 3101 Pollok Drive • Conroe, Texas • USA • 77303 • P: 936.788.5593 • F: 936.788.5720
Page 69 NJEX 8300 ver.092001 ATEX Rev.
SSSSS
ECTION ECTION ECTION ECTION ECTION
11: 11:
11: 11:
11: S S
S S
S
Y YY Y YSTEM STEM STEM STEM STEM
O O
O O
O
PERA PERA PERA PERA PERATION TION TION TION TION
A decrease in the Verometer Level should be observed.
Close valve
V3 and press the Up Arrow key four times
to return to the main menu.
Choose the *Start entry from the main menu,
figures
188 . The meter level display will indicate the Verometer
level as the verometer refills to 100%.
Next, choose the mode of operation in the Proportional-to-
Flow or Time display, for either the
*Flow or *Time entry,
figure 189.
Note: the *Time option will not appear if disabled at the
time interval setting,
refer to Section 6: Programming for
Proportional-to-Time Operation, page 33, Time Interval
between strokes of the pump...
.
To start the pump press the *Yes entry, figure 190 .
If the calculated time / stroke is less than the minimum,
the
Time / Stroke Calculated Exceeds Minimum
display will appear, and the system will not start,
figure
191 . Refer to Section 5, page 27, Proportion-to-Flow
Mode, Setting Operator Input Parameters, to set the
correct parameters for the NJEX 8300G System.
The Prop Flow / Time x:xx:xx display that follows,
figure
192, provides a count down to the next pump stroke.
To Stop The System
To stop the pump, in the Prop Flow/Time x:xx:xx
display,
figure 192,
press the *Stop entry. The following
Stop Pump display, figure 193, then provides the option
to press the *No or *Yes entry. Press the *Yes entry to
stop the pump.
Figure 188
pmp bat vmtr sig tnk
PropFlow Stop
*Start *Dsp *Set
Figure 188
pmp bat vmtr sig tnk
Meter Level 000%
Filling
Select
Enter
pmp bat vmtr sig tnk
Proportional to?
*Flow *Time *Esc
pmp bat vmtr sig tnk
Start Pump?
*Yes *No *Esc
pmp bat vmtr sig tnk
Prop Flow/Time 0:00:00
*Stop *Dsp *Set pmp bat vmtr sig tnk
Time/Stroke Calculated
Exceeds minimum
pmp bat vmtr sig tnk
Stop Pump?
*Yes *No *Esc
Figure 189
Figure 190
Figure 191 Figure 192
Figure 193