YZ Systems NJEX 8300G, Manual, Page: 34 / 126

YZ Systems, Inc. • 3101 Pollok Drive • Conroe, Texas • USA • 77303 • P: 936.788.5693 • F: 936.788.5720
Page 27 NJEX 8300 ver.092001 ATEX Rev.
SSSSS
ECTION ECTION ECTION ECTION ECTION
5: 5:
5: 5:
5: P P
P P
P
R RR R ROGRAMMING OGRAMMING OGRAMMING OGRAMMING OGRAMMING FOR FOR FOR FOR FOR
P P
P P
P
R RR R ROPOR OPOR OPOR OPOR OPORTION TION TION TION TIONAL AL AL AL AL
-----
TTTTTO O O O O
-F -F
-F -F
-F
LLLLLO O O O OW W W W W
O O
O O
O
PERA PERA PERA PERA PERATION TION TION TION TION
value. When a new value has been chosen, press the
Enter key to store the new value into memory. The
entered value will stop flashing when it has been loaded
into the memory. Press the
Down Arrow key to
advance to the next parameter.
The maximum time/stroke setting , is the maximum
time between strokes, when a stroke time is actually
calculated, desired regardless of the time calculated by
the controller.
This feature is not active under low-flow or
no-flow conditions.
To set the maximum time/stroke ,
figure 47,
press and
release the Select key. The value entry will begin to
flash when selected. Use the Up Arrow key to increase
the value and the Down Arrow key to decrease the
value. When a new value has been chosen, press the
Enter key to store the new value into memory. The
entered value will stop flashing when it has been loaded
into memory. Press the
Down Arrow key to advance to
the next parameter.
The odorant output setting , controls the scaling of the
odorant output relay in lbs/pulse (kg/pulse) . This
indicates how much odorant has been injected with
each pulse of the output relay located
TB1 , terminals
#19 and #20 ,
refer to the Wiring Control Document on
page 117 in Appendix D.
To set the odorant output ,
figure 48,
press and
release the Select key. The value entry will begin to
flash when selected. Use the Up Arrow key to increase
the value and the Down Arrow key to decrease the
value. When a new value has been chosen, press the
Enter key to store the new value into memory. The
entered value will stop flashing when it has been loaded
into memory. Press the
Down Arrow key to advance to
the next parameter.
Or
pmp bat vmtr sig tnk
Odorant Output
0.010 lbs/pulse
pmp bat vmtr sig tnk
Odorant Output
0.010 kg/pulse
Select
Enter
Figure 48
pmp bat vmtr sig tnk
Maximum Time/Stroke
0 = Disabled
Select
Enter
Figure 47