YS-e Instruction Manual 76-QD0444EN-00Y01-00.doc
18
7. Functions of throttle lever and reverse lever
Throttle lever
When the throttle lever is pulled after insertion of
the battery pack or during SLEEP status, the tool is
activated. When the throttle lever is pulled again
after the tool is activated, the main shaft of the tool
rotates. Depending on the pulling level of the
throttle lever, the rotation speed is switched to low
and middle. If the throttle lever is lightly pulled, the
rotation speed is set to low. If the lever is pulled
more, the rotation speed is set to middle.
Reverse lever
Reverse lever is intended for switching the
rotation speed of the main shaft. If you press
R-side of the reverse lever and pull the throttle
lever, the main shaft rotates right. If you press its
L-side and pull the throttle lever, the main shaft
rotates left.
*While the main shaft rotates, do not operate the
reverse lever.
8. Method of adjustment of output
Output torque is adjusted by changing the no-load rotation speed of the motor.
If the no-load rotation speed is increased, the output of the tool becomes bigger, and if it is decreased,
the output becomes smaller. The setting of rotation speed is saved in the wireless unit and it is to be
changed by the browser for WU-1 or PC-1. For the details of setting method, see the instruction manual
for WU-1 or PC-1.
Left
RIght
Push the L-side
(reverse rotation)
Push the R-side
(right rotation)
Cut Torque
Torque is not reaching to the cut
torque or it takes time for reaching
to the cut torque.
↓
RPM should be increased.
Torque rises up quick but the tightening
torque is unstable.
↓
RPM should be lowered.
Output Torque
Tightening time
