YS-e Instruction Manual 76-QD0444EN-00Y01-00.doc
17
6. Single operation mode
The tool can be operated alone by the following steps.
*In single operation mode, the tool does not shut off automatically.
The set values cannot be changed and all data such as tightening results, tightening
waveforms are not stored.
To release the single operation mode, remove and insert.
6.1. Install the battery into the tool.
6.2. While the pressing the pairing button of the tool, pull the throttle lever and release it.
Press the pairing button of the tool with TF pin 2×90.
6.3. Release the pairing button of the tool.
If the LED of the tool blinks in white, the single mode of the tool is completed.
