YS-e Instruction Manual 76-QD0444EN-00Y01-00.doc
7
・
Handle the power tool carefully. Abuse may cause accident and/or malfunction. Do not give impacts on it
by throwing or dropping it.
・
Do not make the foreign object such as metal pieces, invaded to the product. There is fear of fire.
・
Fix the work piece (object to be tightened) securely. If the fixing is insufficient, the work piece (object to
be tightened) may be dispersed and it may cause injury.
・
Put the attachment securely on the tool before pulling the throttle lever.
・
NEVER bring your hand or a cloth and so on to the moving part of the tool.
・
Take a break as appropriate. Continuous and long work may cause diseases.
・
If you feel problem continuously or intermittently such as numbness, sting, pain, chlorosis, burning
sensation, stiffness, inform the responsible manager in charge and get the doctor
’
s diagnosis.
・
NEVER make any modification to the tool. Doing so could result in accidents. In addition, never use the
spare part other than the genuine one.
・
Do not remove the parts from the tool. If you use such tool as the mounted parts or screws removed, it
may cause accident.
・
Keep the tool away from the moving parts of plant facility. Otherwise, the tool may be entangled or
pinched and it may be damaged.
・
When the tool is damaged, stop using it immediately. In addition, to avoid the use of the damaged tool,
identify it as damaged and separate it from normal ones.
・
If you feel uneasiness during the use, stop using the tool immediately and ask repair and inspection to
YOKOTA or YOKOTA-authorized or designated servicing factory via the sales outlet or sales
representative. If any accident or problem occurs due to the customer
’
s intended action such as
disassembly of this product, we shall not be liable for such trouble.
・
Be sure to check the direction of reverse lever of the power tool before operation. Be sure to switch the
rotational direction while the power tool stops.
・
Pull the throttle lever of the tool slowly to start. Sudden start may cause accident or malfunction.
・
Engage the socket or bit securely into the bolt and nut.
If the socket comes off from the bolt, during the operation, it is very dangerous.
・
Hold the tool securely to be prepared for the reaction force. Reaction force may push you around when
tightening.
・
When running the tool at no load, be sure that the tip tool (like socket, bit and so on) was removed without
fail and be careful around the surroundings. The operation at no load for a long time will cause the part
breakdown with seizure, early wear and so on.
・
Be careful about burn injury. Immediately right after tightening, metal parts, accessary, bolts and nuts
may be hot.
・
Do not stick the pin, bar and so on into the inlet and exhaust of the cooling fan nor plug the hole.
