<6. Operation>
6-2
IM 01W07D01-01EN
Provisioning Work
This subsection describes provisioning work using
FieldMate as the provisioning device.
Provisioning work performs provisioning for each
field wireless device using FieldMate and an
infrared adapter.
When using the Yokogawa recommended near
infrared adapter for the provisioning device, the
distance between the front panel of this product
and the infrared surface of the near infrared
adapter should be within 30 cm. For details on the
Yokogawa recommended infrared adapter, refer to
subsection 8.2 “Recommended Products List”.
Perform the following provisioning tasks.
• Setting provisioning information
• Creating a provisioning information file
(1) Setting provisioning information
Set the device tag and Network ID using a
FieldMate provisioning function. The device tag,
Network ID, and join key are set in the field wireless
device. It is not necessary to input a join key
because FieldMate automatically generates it.
Table 6.1
Provisioning Information
Rule
Limit
Device Tag Set the different unique
name each for the devices
connected to the same
wireless network.
Up to 16
characters
Network ID Set the same id for the
same wireless network.
2 to 65535
The field wireless device is connected to the field
wireless network corresponding to the Network ID
set by provisioning work.
(2) Creating a provisioning information file
The following provisioned information is stored in
the provisioning information file.
• Network ID
• Device tag
• EUI64
• Join key
• Provisioner (name of the user who performed
provisioning work by FieldMate)
• Date (Time and date when provisioning was
performed by FieldMate)
This provisioning information file is required to
load the device information to YFGW410 Field
Wireless Management Station by Configurator
of Field Wireless Management Console (FWMC
Configurator). Store the file carefully.
Connecting to a Field Wireless Network
The action after installing the battery pack varies
depending on the silence setting.
Mounting the battery pack automatically starts a
search for the field wireless network and the device
goes into the join state when the field wireless
gateway is found. If the field wireless gateway is
not found and a specified time based on the silence
mode has elapsed, a cycle of 18-minute pause and
36-second search is repeated until the device can
join the field wireless network.
Mounting battery pack
Ready1:
Searching
Boot
Pause
Operation
Confirm
connecting
Status: Join
Search failure for
the specified time
Ready2:
Searching
18 minutes
passed
Search failure
for 36 seconds
(Connect)
(Disconnect)
(Publish)
(Disconnect)
(Connect)
F0602.ai
Figure 6.2
Wireless Status Transition
6.3 Checking the Device
Conditions
Check the conditions of the WN100 as the following
steps.
Step 1: Check that Join Status of WN100 is “Full
Join” on FWMC Monitor.
Step 2: Read Diag Status of UAPMO block with
FieldMate, and check any errors are not
detected.
6.4 Shutting Down
When shut down the WN100, remove the battery
pack.
NOTE
Refer to subsection 8.4.1 “Replacing the Battery
Pack” for the battery pack removing.
