YOKOGAWA TB820D, User Manual, Page: 34 / 87

<4. SETTING PARAMETERS>
4-1
IM 12E01B30-02EN 2nd Edition : June 09 , 2021-00
4. SETTING PARAMETERS
This chapter describes all Sensor setting and Auto wash/Cal setting as a part of converter menu.
About other setting parameters of the converter menu, read FLXA402T Operation of Converter.
To go to Sensor setting menu, refer to 5.5 Setting. To go to the converter menu, refer to FLXA402T
Operation of Converter IM 12A01G01-03EN .
Table 4.1 Sensor setting
Menu Parameter Default Reference
Measure setting Negative value non output Disable 4.1.1
Turbidity unit select mg/L 4.1.2
User-defined unit
Meas. damping time constant 20.0 sec 4.1.3
Turbidity warning High limit 9999 (*1) 4.1.4
Turbidity warning Low limit -10.0 (*1)
Air denoising
setting
Air denoising function Disable 4.1.5
Air noise detection value 999.9 (*1)
Air denoising hold time 30 sec
Denoising release time 30 sec
Cal./Maint. settings Turbidity value of check tool 90.0 (*1) 4.2.1
Maint. damping time constant 6 sec 4.1.3
Zero shift value 0.0 4.2.2
Correction factor 1.0
Stability check allowable width *2 4.2.3
Stability checking time 10 sec
Stability check limit time 1.0 min
Wash/Cal. box Disable 4.2.4
Ultrasonic wash Disable 4.2.5
Calibration setting
others
Zero *2 4.2.6
Slope 100.0%
Sens.factor *2
Linearize
table
point 1. X value *2
Y value *2
point 2. X value *2
Y value *2
point 3. X value *2
Y value *2
point 4. X value *2
Y value *2
point 5. X value *2
Y value *2
point 6. X value *2
Y value *2