<8. Setting Parameters>
8-9
IM 01C27B01-01EN
• Transducer Value.
Status
• Transducer Value.
Value
• UAPMO
Menu (Online)
(continued)
(Diagnostic)
F0803-3.ai
• Device Diagnostics
(UAPMO)
• Diagnostic Status
• Diagnostic Status Detail.1
• Diagnostic Status Detail.2
• Diagnostic Switch
• Diagnostic Configuration
(Diagnostics)
• Energy Left
• Power Supply Status
• Power Supply Voltage
(Power Status)
• AI1 DP
• AI2 SP
• AI3 Temp
(Process Variable)
• Process Variable
(AI1 DP)
• Process Value
• Simulation
(Dynamic
Variables)
• Process Value.Status
• Process Value.Value **
(Process Value)
• Simulate Switch
• Transducer Value
• Simulate Value
(Simulation)
(Transducer Value)
• Simulate Value.
Status
• Simulate Value.
Value
(Simulate Value)
• Process Variable
(AI2 SP)
• Process Value
• Simulation
(Dynamic
Variables)
• Process Value.Status
• Process Value.Value **
(Process Value)
• Simulate Switch
• Transducer Value
• Simulate Value
(Simulation)
• Process Variable
(AI3 Temp)
• Process Value
• Simulation
(Dynamic
Variables)
• Process Value.Status
• Process Value.Value **
(Process Value)
• Simulate Switch
• Transducer Value
• Simulate Value
(Simulation)
• Transducer Value.
Status
• Transducer Value.
Value
(Transducer Value)
• Simulate Value.
Status
• Simulate Value.
Value
(Simulate Value)
• Transducer Value.
Status
• Transducer Value.
Value
(Transducer Value)
• Simulate Value.
Status
• Simulate Value.
Value
(Simulate Value)
• Diagnostic.Other Faults
• Diagnostic.Faults Non-Compliance
• Diagnostic.Faults Process Influence
• Diagnostic.Simulation Active
• Diagnostic.Soft Update Incomplete
• Diagnostic.Power Low
• Diagnostic.Power Critical Low
• Diagnostic.Fault Prediction
• Diagnostic.Environmental Conditions
• Diagnostic.Outside Sensor Limits
• Diagnostic.Out of Service
• Diagnostic.Calibration Problem
• Diagnostic.Faults Sensor or Actuator
• Diagnostic.Faults Electronics
(Diagnostic Configuration)
*:
When the data of these parameters is rewritten, it is necessary to set the operational mode of the block to O/S (Out of Service).