<2. Handling Cautions>
2-1
IM 01C27B01-01EN
2. Handling Cautions
This chapter provides important information on how
to handle the transmitter. Read this carefully before
using the transmitter.
EJX Series transmitters are thoroughly tested at the
factory before shipment. When taking delivery of an
instrument, visually check them to make sure that
no damage occurred during shipment.
Also check that all transmitter mounting hardware
shown in figure 2.1 is included. If the transmitter
is ordered without the mounting bracket and the
process connector, the transmitter mounting
hardware will not be included. After checking the
transmitter, carefully repack it in its box and keep it
there until you are ready to install it.
No antenna is provided for Amplifier
housing code 9.
Bolt
Process connector
Process connector gasket
U-bolt nut
Mounting bracket
(L type)
Transmitter
mounting bolt
Spacer
Mounting bracket
(Flat type)
F0201.ai
U-bolt nut
Transmitter
mounting bolt
U-bolt
U-bolt
Antenna
Figure 2.1
Transmitter Mounting Hardware
2.1 Model and Specifications
Check
The model name and specifications are written on
the name plate attached to the case.
: Refer to USER'S MANUAL.
Made in Japan
TOKYO 180-8750 JAPAN
MODEL
SUFFIX
SUPPLY
OUTPUT
MWP
mA DC
V DC
STYLE
CAL
RNG
NO.
F0202.ai
Figure 2.2
Name Plate
• QR Code
The product has a QR Code pasted for efficient
plant maintenance work and asset information
management.
It enables confirming the specifications of
purchased products and user’s manuals.
For more details, please refer to the following
URL.
https://www.yokogawa.com/qr-code
QR Code is a registered trademark of DENSO
WAVE INCORPORATED.
2.2 Unpacking
Keep the transmitter in its original packaging to
prevent it from being damaged during shipment.
Do not unpack the transmitter until it reaches the
installation site.
