YETI SNOWMX USER MANUAL
|
34
Soft Strut
Check for excessive play between the Soft Strut’s
lower mount point (
1
) and body (
2
). If play is more
than 3 mm, replace the Strut stem’s inner urethane
bushing. See Figure 72.
Figure 72
Adapters - Bike Mount
Raise the YETI’s rear above the ground and check
for excessive lateral play at Bike Mount points
where the System attaches to the bike. If play is
too great, verify and replace the nylon bushings(
1
).
Voir la Figure 73.
Figure 73
ENVIRONMENT
Track Systems are made of varied materials: steel,
aluminum, carbon fiber, rubber, plastic, grease &
oil used by the manufacturer. Please recycle,
reuse,or dispose of components at appropriate
depot facilities when Track Systems come to the
end of their life.
2-YEAR LIMITED WARRANTY
Camso guarantees that the new, unused
YETI
SNOWMX
System (System) installed by an
authorized dealer or distributor is free from any
defects in materials and workmanship during the
period and in conditions described below. When
operating a new
YETI SNOWMX
System, the user
agrees that the present form is applicable and
exclusive, that they have been signified and that
they have been accepted by him/her at the time of
purchase.
The
YETI SNOWMX
Dirt-To-Snow bike conversion
System is covered by a manufacturer warranty
(warranty). The warranty covers manufacturing
defects related with materials and workmanship.
The installation and maintenance of the System is
always the responsibility of the owner.
PERIOD OF COVERAGE
The warranty is valid for a period of twenty-four (24)
months following the date of purchase. This
warranty does not apply to normal maintenance.
The warranty applies exclusively to parts and
components of the conversion System. All paint
defects on the System (frames and components)
are not covered.
The warranty is not valid if the System is not
installed by an authorized YETI network dealer or
distributor.
This warranty specifically excludes any damage or
breakage to the motorcycle and related defects on
the motorcycle, whether or not these were caused
or believed to be caused by the System.
The manufacturer is not responsible for damages,
injuries or loss caused at the time of or after
installing of the System on the motorcycle.
For a warranty to be valid, the System owner must
comply with manufacturer notices and warnings. In
addition, all claims must be accompanied by a proof
of purchase (original receipt or sale contract) and
work or repairs must be performed by an authorized
YETI dealer. All claims not previously approved and
authorized by Camso will be rejected.
The following situations and items are not
under any circumstances covered by the
warranty:
1) Any and all consequential damages, including,
but not limited to, indirect costs, such as towing,
storage, phone calls, renting, transportation,
inconveniences,
insurance
coverage,
reimbursement of loss, loss of time and loss of
revenue, etc.
