YETI SNOWMX USER MANUAL
|
10
• Place mount adapters (
1
) in position outside of
Bike Mount (
2
). Finger tighten the temporary
M8x25mm assembly bolts (
3
) provided, at the
small end of the adapters. See Figure 14.
Figure 14
• Using the provided Mount adapter insertion tool
(
1
) and the M8x25mm bolts (
2
), rotate and
alternate between the tool’s nut (
3
) and bolt (
2
)
to insert mount adapters on both sides of the
Bike Mount. See Figure 15.
NOTE: Rotate slowly and alternate a few times to avoid
jamming the adapter during insertion.
Figure 15
• Remove M8x25mm bolt used to insert Bike
Mount adapter.
NOTE: Apply a thread locker product (e. g. Blue Loctite
242) to Mount adapter assembly bolts.
• Secure adapters to Bike Mount with the longer
M8x25mm bolts (
1
) installed inside (
3
) and the
shorter M8x20mm bolts (
2
) on the outside (
4
).
Tighten bolts to 25 Nm [18 lb-ft]. See Figure 16.
Figure 16
CAUTION: To ensure adequate assembly, the
M8x25mm bolts used to insert the adapters must be
relocated to the
Bike Mount’s front inside M8 holes.
• Insert bushings in mount adapters. Make sure to
match the bushings to the correct adapters.
NOTE: Depending on your bike model, the left and right
adapter bushings are the same or differ. If you
are uncertain about their position, consult the
YETIVERTER tool on YETISNOWMX.CA
AUTOMATIC
CHAIN
TENSIONER
INSTALLATION
• Insert Chain tensioner (
1
) on mount adapter (
2
)
installed on left side of Bike mount. Apply
pressure to insert guard on larger part of adapter.
Next, insert the chain tensioner spring (
3
) in its
seats, in the Chain tensioner and mount adapter.
See Figure 17.
Figure 17
