9
|
YETI SNOWMX USER MANUAL
CAUTION: Clamps must be straight and aligned
before final tightening. Clamp misalignment can
hinder normal operation of forks.
• Tighten, in sequence, the front wheel axle nut (
1
)
and then the pinch bolts (
2
) at the bottom of the
forks to the torque specifications recommended
by the manufacturer of the bike. Figure 10.
• Tighten clamp bolts (
3
) to 25 Nm [18 lb-ft] of
torque. See Figure 10.
NOTE: Use an alternate tightening sequence between
the 4 clamp bolts (
3
) to distribute force equally.
Figure 10
SKI INSTALLATION
Assemble ski to spindle as follows:
• Check if «FRONT» marking under ski rubber is
positioned towards front of ski. Figure 11.
Figure 11
• Position ski (
1
) to spindle (
2
) and align holes in
ski’s base with mounting hole in spindle. Insert
M10x110mm bolt (
3
) and secure with M10
locking nut (
4
). Tighten assembly to 55 Nm
[38lb-ft] of torque. See Figure 12.
Figure 12
REAR SYSTEM PREPARATION
VERIFICATION OF ADAPTERS AND BUSHINGS
Check that the mount adapters and bushings
received match your bike’s model. These parts are
identified by a number inscribed on each one;
consult
the
YETIVERTER
tool
on
YETISNOWMX.CA to confirm the parts and identify
their installation position.
MOUNT ADAPTER INSTALLATION
Assemble mount adapters to Bike Mount as
follows:
NOTE: Make sure to assemble the correct adapters on
the Bike Mount’s left (
1
) and right (
2
) sides.
• Apply lube on the portion of adapters inserted in
Bike Mount. Figure 13.
Figure 13
LUBE