Digital Operator Functions
6-
155
An error may occur during the comparison. If an error is displayed, press any key to cancel the error display
and return to the o3-01 display. Error displays and their meanings are shown below. (Refer to
Chapter 7
Errors when Using Digital Operator Copy Function.)
Application Precautions
•
When using the copy function, check that the following settings are the same between the Inverter and the
Digital Operator.
•
Use the copy function off-line or with a communications option board removed.
•
A CPF03 fault (EEPROM error) can occur if the power is shut down while the Inverter constants are being
copied. Do not shut down the power while copying the constants.
3
Display o3-01 (Copy Function Selection) using the Increment Key and Decrement
Key.
4
Press the DATA/ENTER Key, and select the function setting display.
5
Change the set value to 3 using the Increment Key.
6
Set the changed data using the DATA/ENTER Key. The VERIFY function will
start.
7
If the VERIFY function ends normally, End is displayed on the Digital Operator.
8
The display returns to o3-01 when a key is pressed.
Error Display
Meaning
Verify error (Settings in the Digital Operator and the Inverter do not match).
Inverter product code and Inverter software number are different.
•
Inverter product and type
•
Inverter capacity and voltage
•
Software number
•
Control method
Table 6.3 VERIFY Function Procedure (Continued)
Step
No.
Digital Operator Display
Explanation
COPY Function
-ADV-
o3
- 01=0
Copy Funtion Sel
Copy Funtion Sel
-ADV-
o3-01=
0
COPY SELECT
*0*
Copy Funtion Sel
-ADV-
o3-01=
3
OP
←→
INV VERIFY
*0*
VERIFY
-ADV-
DATA VERIFYING
VERIFY
-ADV-
VERIFY COMPLETE
Copy Funtion Sel
-ADV-
o3 -
01
=0
COPY SELECT
*0*
VYE
VERIFY ERROR
CPE
ID UNMATCH
