7
CAUTION
Observe the following cautions to prevent personal indury due to improper
handling.
•
Do not use the welder with the case or cover removed.
•
Only a trained or qualified person must remove the welder case for
maintenance and inspection or repair. Take preventive measures not to
let other personnel approach the welder or welding sites unnecessarily by
putting upa guard fence or the like.
•
Do not contact the rotating cooling fan or feeding roll of the wire feeder with hands, fingers, hair,
or clothes.
Failure to observe this caution may cause someone to be caught in the machine resulting in personal injury.
Observe the following cautions to prevent personal injury by the end tip of the
welding wire.
•
Do not peep through the chip hole to confirm that the wire is being fed.
If the wire is projected from the end tip of the weld wire guide, it may poke you in
the eyes or face.
•
Do not bring the welding torch end close to eyes, face, or body to perform
inching or pulling the torch switch.
If the wire is projected from the end tip of the weld wire guide, it may poke you in the eyes, face, or body.
When hanging the wire feeder, remove the anti-fall fastner downward from the spool shaft and
tighten.
Failure to observe this caution may cause the wire to be removed from the spool shaft, resulting in personal
injury.
Observe the following cautions to prevent a fire accident caused by deterioration of welder
insulation.
•
Perfom all welding and grinding away from welder to protect welder from
spattering and metal powder.
Spatter and metal powder inside the welder may cause a deterioration of insulation
resulting in accidental fire.
•
Be sure to perform maintenance and inpsection periodically to prevent
deterioration of insulation caused by accumulation of dust and dirt.
•
If spatter or metal powder enters the inside of the welder, remove it by forced air sprot after
turning OFF the welder and switch in the switch box.
Spatter and metal powder inside the welder may cause a deterioration of insulation resulting in accidental
fire.
Summary of Contents for MOTOWELD-T300D
