YASKAWA HV600, Technical Reference

Page: 50 / 794

2.7 Removing/Reattaching Covers
50 YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference
◆
Removing/Reattaching the Drive Cover Using Procedure A
DANGER! Electrical Shock Hazard. Do not examine, connect, or disconnect wiring on an energized bypass. Before servicing,
disconnect all power to the equipment and wait for the time specified on the warning label at a minimum. The internal capacitor
stays charged after the bypass is de-energized. The charge indicator LED extinguishes when the DC bus voltage decreases below
50 Vdc. When all indicators are OFF, remove the covers before measuring for dangerous voltages to make sure that the bypass is
safe. If you do work on the bypass when it is energized, it will cause serious injury or death from electrical shock.
■
Remove the Front Cover
1.
Remove the bypass front cover in Procedure A
2.
Loosen the front cover screw.
Figure 2.20 Loosen the Front Cover Screw
3.
Push on the tabs in the sides of the front cover then pull the front cover forward to remove it from the drive.
Figure 2.21 Remove the Front Cover
■
Reattach the Front Cover
1.
Wire the drive and other peripheral devices.
2.
Reverse the steps to reattach the cover.
Note:
• Make sure that you did not pinch wires or signal lines between the front cover and the drive before you reattach the cover.
• Make sure that the tabs on the sides of the front cover correctly click into the hook.
• Tighten the screws to a tightening torque of 0.98 N
∙
m to 1.33 N
∙
m (8.67 in
∙
lb to 11.77 in
∙
lb).