YASKAWA GA80U Series, Installation & Primary Operation, Page: 80 / 168

10 Drive Start-Up
80 YASKAWA TOEPC71061737D GA800 DRIVE INSTALLATION & PRIMARY OPERATION
3.
Put the wires through the clearance in the wiring cover.
Figure 10.10 Control Circuit Wiring
4.
On drive models 4810 to 4H12, wire the drive control circuit as shown in Figure 10.11 or Figure 10.12 .
NOTICE Damage to Equipment. Use tubing or other protection for the wires to prevent damage to the wires at the
edges of the opening. If there is damage to the wires, it can cause incorrect operation.
Note:
When you wire the control circuit wiring outside the drive, use the slits on the sides of the drive and safety the wires with cable
ties. You can wire on either the left or right side.
Figure 10.11 Wiring Inside the Drive
A - Opening B - Slit to Safety Wires
Figure 10.12 Wiring Outside the Drive
5.
Install the LED status ring board, front cover, and the keypad to their initial positions.
◆
Switches and Jumpers on the Terminal Board
The terminal board has switches to adapt the drive I/Os to the external control signals as shown in Figure 10.13 .
Set the switches to select the functions for each terminal.