YASKAWA GA800 Series, Maintenance & Troubleshooting

Page: 455 / 566

Startup
Procedure
and
T
est
Run
6
6.6 Keypad Operation
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting 455
The screen will show the monitors as shown in this figure.
◆
Set the Monitors to Show as Analog Gauges
The procedure in this section shows how to show the frequency reference monitor as an analog gauge.
1.
Push [Home] to show the HOME screen.
Note:
• The keypad will [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push [Back] to show [Home] on .
2.
Push [Menu].
3.
Push or to select [Monitors], then push .
4.
Push or to select [Analog Gauge], then push [Setup].
5.
Push .
6.
Push or to select the monitor number to register, then push .
Monitor Set the x-xx part of the Ux-xx . For example, to show monitor U1-01 [Frequency Reference] , set it to
"101" as shown in this figure.