YASKAWA GA800 Series, Maintenance & Troubleshooting

Page: 327 / 566

Mechanical
Installation
4
4.8 Removing/Reattaching Covers
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting 327
■
Reattach the Front Cover
Wire the drive and other peripheral devices then reattach the front cover.
Note:
Wire the grounding terminals first, main circuit terminals next, and control circuit terminals last.
1.
Move the front cover to connect the hooks at the top of the front cover to the drive.
A - Hooks
Figure 4.28 Reattach the Front Cover
2.
Move the front cover until it clicks into position while pushing on the hooks on the left and right sides of the
front cover.
Note:
Make sure that you do not pinch wires or signal lines between the front cover and the drive before you reattach the cover.
Figure 4.29 Reattach the Front Cover
3.
Reattach the keypad to the original position.
■
Remove the Terminal Cover
1.
Loosen the screws on the terminal cover, then pull down on the cover.
CAUTION! Crush Hazard. Loosen the cover screws. Do not fully remove them. If you fully remove the cover screws, the
terminal cover can fall and cause moderate injury.
Figure 4.30 Loosen the Terminal Cover Mounting Screws