YASKAWA GA800 Series, Maintenance & Troubleshooting

Page: 449 / 566

Startup
Procedure
and
T
est
Run
6
6.6 Keypad Operation
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting 449
6.6 Keypad Operation
Note:
Make sure that you use a keypad that has a flash number of 1004 or later. Keypads that have a flash number of 1003 or earlier will not show
characters correctly.
◆
Home Screen Display Selection
This section gives information about the content shown on the HOME screen and the functions that you can control
from the HOME screen.
■
View Monitors Shown in Home Screen
This figure shows monitor data in the data display area of the HOME screen.
•
To change what the screen shows, change the setting for o1-40 [Home display selection] .
• When o1-40 = 0 [Home Screen Display Selection = Custom Monitor] , and there is more than one screen, use
or to switch between screens.
■
JOG Operation
Push to illuminate . Push and hold [JOG] to run the motor. Release [JOG] to stop the
motor.
■
Change Motor between Forward/Reverse Run
You can change the direction of motor rotation when operating the drive from the keypad. Push to illuminate
.
Push and hold [FWD/REV] to toggle the direction of motor rotation between forward and reverse.
■
Show the Standard Monitor
Push to show the standard monitor ( Ux-xx ). When you push [HOME], the keypad goes back to the home
screen.
Note:
When a fault, minor fault, or an error occurs, push to show the content of the fault. Push again to show the standard monitor ( Ux-
xx ).