STARTER MOTOR
10-12
TNV IDI Service Manual
Starter Motor
Measure Commutator Insulation Depth
Measure the depth of the insulating material
(Figure 10-14, (1))
between commutator segments
(Figure 10-14, (2))
. If the depth measures less
than the limit, use a hacksaw blade
(Figure 10-14, (3))
to remove the insulating
material until the depth is within the limit.
Starter Motor Specifications on page 10-5 for
service limit.
A normal commutator condition is indicated in
(Figure 10-14, (4))
. An abnormal commutator
condition is indicated in
(Figure 10-14, (5))
.
Figure 10-14
Armature Coil Continuity Test
Check for continuity between the commutator
segments using a multimeter
(Figure 10-15)
. The
multimeter should indicate continuity.
If the multimeter does not indicate continuity,
replace the armature.
Figure 10-15
Armature Coil Insulation Test
Check for continuity between a commutator
segment and the shaft or armature using a
multimeter
(Figure 10-16)
. The multimeter should
not indicate continuity.
If the multimeter indicates continuity, replace the
armature.
Figure 10-16
(3)
(5)
(4)
(2)
(1)
0000118
0000114
0000115
TNV_IDI_ServiceManual_A4.book 12 ページ ２０１２年２月２４日 金曜日 午前１０時２４分
