Yamaha YZFR1W 2007, Service Manual

Page: 68 / 429

CABLE ROUTING
2-40
1. Ground lead
2. Meter lead
3. Headlight stay
4. Right headlight lead (high beam)
5. Right auxiliary light lead
6. Intake air temperature sensor coupler
7. Headlight lead
8. Left Auxiliary light lead
9. Left headlight lead (high beam)
10.Right console panel
11.Right intake air duct
12.Left intake air duct
13.Left console panel
A. Insert to the rib of the head light.
(Either location of the right and left relays is
acceptable.)
B. The lead should not stretch too much.
Direction of the ground terminal can be
either top side or flip side.
C. Make sure to insert the coupler and boot to
the stay hole.
D. The speedometer lead should not be
strained.
E. To the headlight stay hole
F. Route by the rear side of the vehicle away
from the right auxiliary light lead.
G. Connect after passing over the upper side
of the duct.
H. To the turn signal light
I. Paste the latch of the clamp to be posi-
tioned toward the rear side of the vehicle.
J. There should be no slack when clamping.
Point the tip of the clamp (excessive part)
to the front side of the vehicle.
Fasten the headlight lead with a clamp.
K. Clamp the headlight lead.
Cut the tip of the clamp.
L. To the wire harness
M. Route by the rear side of the vehicle away
from the left auxiliary light lead.
N. Feed a lead wire through the U shape cut-
out of the console panel.